Better Than PLA and ABS
Mechanically and Thermally
What do these terms mean?
- Heat Deflection Temperature: measure of a polymer’s ability to bear a given load at elevated temperatures; the temperature at which it deforms.
- Flexural Modulus: pressure required to start the bending; stiffness; the tendency of the material to bend.
- Flexural Strength: pressure required before a certain degree of deformation; degree of deformation at which the test fails.
- Tensile Yield Strength: maximum stress before breaking when being stretched from both ends.
Workday PLA (APLA) Heat Resistance Comparison
3D-Fuel Workday PLA filament is being produced from high heat grade PLA, developed specifically for the manufacturing of 3D printer filament.
High heat grade resin exhibits improved heat resistance and has faster crystalization rates. We use only genuine, Natureworks Ingeo resin for our Workday PLA filament.
When using 3D-Fuel filament made from this resin you can expect:
- Low odor
- Higher print detail/resolution
- Excellent first layer adhesion
- Improved adhesion between layers
- Reduced warping, curling, and failed prints
It is essential to ensure filaments are dry prior to printing. Our filament will run best at an extrusion temperature of 190-230C. It is recommended to use high water content hair spray (as opposed to high ethyl alcohol content) or painter’s tape on the build plate to ensure the first layer of the print sticks to the plate. PEI (with a heated bed), BuildTak, and direct printing on acrylic can also produce good results.
For more stability and a higher quality print:
- Reduce the speed of the extruder to 30-60mm/second
- Increase infill to 30%
- Reduce layer height to 0.10mm
- For prints with curvatures, it is recommended to turn on rafts and supports in your settings.
- Print in an area with good airflow and/or and active cooling fan that directs airflow directly on the print.
- Clean the base plate after each day of printing.
- Clean the nozzle after every use for best performance.
Annealing (Heat Treating) Info
To get the maximum strength out of your 3D printed part, we recommend a post- annealing procedure that could be done in your oven at a range of 176-266F (80- 130C) to promote increased crystallization and further improve the heat deflection temperature.
For best results:
- Preheat the oven or toaster oven.
- Place print on room temperature baking sheet.
- Place baking sheet into oven/toaster oven.
- Wait 30-60 minutes for annealing to complete
- You may see the print take on a milky/matte/opaque color transformation.
- Turn the oven off.
- Wait for oven to cool before removing print.
Shrinkage and/or warping may occur. The degree of shrinkage/warping depends heavily on the part geometry.
The Best Filament. Fueling Your Creativity™
Take a look at our selection of Workday PLA/APLA colors below and find a reseller to begin printing with the best.